|
flowtest.bmp |
Flowtest
comparison of a Batten Head vs. Bulldog
ROP thread:
http://www.huntracing.net/phpBB2/viewtopic.php?t=12247 |
|
silicon_map_sheet.bmp |
A map sheet
showing the proper location for silicon application on a Olds engine
with copper head gaskets. Original diagram provided by Andy
Miller |
|
crank_overlap.BMP |
This one
appeared on DRR at the request of Scott Smith. It shows cranks
pin overlap with a 4.125" stroke crank with Honda rod journals. |
|
crank_seal.bmp |
This
drawing show how to properly install a molded main seal in an Olds
engine. |
|
oil_pan.bmp |
This is a
diagram of how I construct a expanded metal screen in nearly any
Olds oil pan. |
|
camber.bmp |
Part 1 of 3
Shows how to do a basic camber measument on a A-body type car
without any special tools so you can drive it to an alignment shop. |
|
caster.bmp |
Part 2 of 3
|
|
toe.bmp |
Part 3 of 3 |
|
oilpassA.bmp |
Part 1 of a
drawing showing the position of oil passages in a crankshaft. |
|
oilpassb.bmp |
Part 2 of a
drawing showing the position of oil passages after crankshaft
destroking procedure. |
|
oilflow.bmp |
Shows how
the oil hole changes position when the rod journal is ground. |
|
4-link.bmp |
Shows how
to check rearend position within chassis. |
|
panhard.bmp |
This
drawing shows the lateral displacement caused by using a panhard bar
in a drag car. |
